Admira Protect – light-curing, fluoride-releasing one-component Ormocer-based preparation for the treatment of dentine hypersensitivity.
Admira Protect completely reduces hypersensitivity, in most cases after only one application, and additionally protects against external influences and abrasion.
Treatment of hypersensitive dentine.
Treatment of cervical areas (including crown margins, after tooth cleaning or tartar removal, exposed cervical areas following surgery etc.).
Admira Protect – Method of use:
Clean teeth to be treated with fluoride-free cleaning paste or pumice on a rubber cup or rotating brush. Isolate areas to be treated with cotton rolls. Remove excess moisture with an oil-free airjet. Do not overdry dentine. The dentine surface should be slightly moist. After cleaning, avoid any contamination with blood or saliva.
When using the bottle:
Dispense Admira Protect onto a Micro Tim or a disposable brush. Alternatively, dispense Admira Protect onto a mixing pallet.
When using the SingleDose:
Detach a SingleDose at the perforated line and turn the printed side upwards. Break through the foil with Micro Tim, enlarge the gap and moisten the brush with liquid through circular motion.
Apply with Micro Tim or a disposable brush evenly on all dentine surfaces to
be treated and allow to act for 20 s. Then disperse Admira Protect with a faint airjet and lighcure with a conventional polymerisation device for 10 s. The light output should be a minimum of 500 mW/cm2 on halogen polymerisation devices and 300 mW/cm2 on LED devices. Apply a second layer of, disperse it with a faint airjet and light-cure for 10 s.
4. Removal of the inhibition layer
Remove the oxygen-inhibited layer (soft surface)with a cotton pellet or a cotton roll. Check the gingival margins and, if necessary, remove any residual material.
Phenolic substances (e.g. eugenol-containing materials) disturb polymerisation and must not be brought into contact with Admira Protect. Contains Bis-GMA, HEMA, BHT, acetone, Ormocer and organic acids. Do not apply in cases of known allergies against ingredients of Admira Protect. Avoid contact with the mucosa. Upon contact with eyes flush immediately with plenty of water and consult a physician.
Storage and application:
Close bottle tightly after use. Store at temperatures of 4°C – 23°C (storage at 5°C – 8°C prolongs the shelflife of the preparation). Do not expose to direct sunlight or the chairlight.
Admira Protect bottle 4.5 ml, accessories
- 50 SingleDose, accessories
- 200 SingleDose, accessories
ULTRAEZ – DESENSITIZING GEL WITH POTASSIUM NITRATE AND FLUORIDE
ISODAN – DESENSITIZING SOLUTION
DYCAL – CALCIUM HYDROXIDE LINER